Can anybody tell me which of the custom commands can be used after a IGEL client wakes up from standby?
It should also run after applying profile changes.
I would check Reconfiguration then, even if I‘m not sure to 100% if it applies to Wake up…
So there a no detail information available about the custom commands? Would be very helpful to see the sequence how they will be applied.
There is, sure: kb.igel.com/igelos-11.08.330/en/custom-commands-88022068.html kb.igel.com/igelos-11.08.330/en/custom-commands-88022068.html
Hey Eric, I posted a “cc-mapper” profile, so that people may analyze some of the triggers and timings around custom commands. Give it a go and see if it helps you: igelcommunity.slack.com/archives/C9XFWLXA8/p1654718727670259 igelcommunity.slack.com/archives/C9XFWLXA8/p1654718727670259
What kind of command are you looking for?
I want to apply IGEL OS firmware with a CC. It work’s on a normal/cold start but It have to be also work after wake up from standy.
Thanks @member! This look very helpful for me.
So it seems this is the standard sequence on a cold boot…
Base-1: Initialization
Desktop-1: Desktop initialization
Base-2: Before session configuration
Network-1: Network initialization
Base-3: After session configuration
Network-2: After network DNS
Base-4: Final initialization command
Network-2: After network DNS
Network-3: Before network services
Network-4: Final network command
Desktop-2: Before Desktop Start
Reconfiguration-1: After reconfiguration
Desktop-3: Final desktop
I will check how it looks for a boot from standby.
Any luck? Curious minds want to learn… 😁
I can’t test it from home 😑
I will test it next week in the Office.
Continue reading and comment on the thread ‘How is the timing of Custom commands’. Not a member? Join Here!
Learn more, search the IGEL Knowledge Base
Ask a question or comment on the above message thread?
Join or log in to the IGEL Community to ask us anything and meet other IGEL customers, partners, and EUC enthusiasts.Submit a question, or Join Today!